Something similar to the hand tracking module, a hard plastic case attached to the headset with the two screws used for the modules.
It will protect the only one connector we will have on the 8KX, if this connector fails no more hand traking, eye traking, cooling fans, just RMAs
Something similar to this;
AFAIK the connectors/screw holes on the bottom should be the same as the previous headsets, so any enthusiastic 3D modelers out there can start designing. It doesn’t need to enclose the connector, it just needs to be a simple spacer to provide an offset of 1-2cm.
Definitively, if Pimax doesn’t provide a solution to protect this connector I’ll print something similar my self
I know pimax is looking for solutions though, and this one is pretty simple
This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.
